 |
 |
|
For
grinding down crushed scrap that is recovered after shredding pipes
and fittings, into powder form (fine mesh size) where the powder
form is to be reused with fresh material.
|
|
 |
 |
|
For
grinding down scrap/rejects produced in the Pipes, Profiles and
Conduits for Agricultural and Housing Segments.
|
|
 |
 |
|
It
is adequate for grinding a wide range of products such as plastic
lumps, Thick section, Blow Molded parts & pinch off, thick section
of profile & pipes, wood waste etc which would be otherwise
be difficult to cut/grind in conventional granulators. This model
is adequate for large production capacities with limited dimension
and power.
|
|
 |
 |
|
For
converting all crushed scrap recovered after all sorts of granulation/
shredding/ agglomeration into granule form reusable with fresh material,
giving the best advantage of homogeneity and mix/ colour dispersion
etc. - highly recommended for most products (except PVC and PET)
|
|
 |
 |
|
For
grinding down scrap/rejects produced in the manufacture of Flexible
packaging (film-use in shopping/medical bag manufacture, tapes-used
in woven sack manufacture, cable coatings, PET bottels for mineral
water/beverages/carbonated soft drinks/juices/oils, etc.)
|
|
 |
 |
|
For
blending, mixing, colouring etc. of raw materials for injection/
blow/ extrusion, for thorough mixing of reground/ pelletised scrap
with scrap with virgin raw material (in granule form).
|
|
 |
 |
|
For
densifying light plastic scrap in the form of flakes recovered after
shredding from the wase shredder. This is converted into compacted
dense material reusable in small particulated form with fresh material
in the production of film/ tapes ec.
|
|
 |
 |
|
For
grinding down scrap/rejects of plastic products in houseware, furniture,
industrial & rigid packaging (crares/paint, food & oil containers),
automotive, agricultural/housing (pipe fittings) segments, both
Injection & Blow moulded.
|
|
 |
 |
|
For
grinding down scrap/rejects of plastic products in houseware, furniture,
industrial & rigid packaging (crares/paint, food & oil containers),
automotive, agricultural/housing (pipe fittings) segments, both
Injection & Blow moulded.
|
|
 |
 |
|
With
the increasing use of PET (a non-bio degradable material) for bottling
domestic consumable products, a need was felt to reclaim these after
end use, to avoid environmental pollution.
R & D at HIMALAYA has resulted in the development of PET washing
line of 500 kg/hr rated output. Flexible plant layout possible to
accommadate in minimum floor space.
|
|
 |
|
